|
|
|
 |
The following is intended to supplement the guidance given with
each product entry in order to give a general overview of installation.
This should not be viewed as a substitute for the Installation
Instructions supplied with the protector. Copies of these are
available on request (CLICK HERE).
Installing parallel connected protectors
for mains power supplies |
 |
Protectors
should be installed very close to the power supply to
be protected, either within the distribution panel or
directly alongside it (in an enclosure to the required
IP rating). |
|
Connections
between the protector and the phase(s), neutral and earth
of the supply should be kept very short. |
|
Protector
performance is enhanced by tightly binding connecting
leads together, over their entire length. |
|
On
supplies rated over 100 amps the phase/live connecting
leads should be fused with suitably rated HRC fuses or
switchfuse, MCCB or MCB. |
|
| |
| 1
| 2 |
| |
|
